With Vitralit UD 8050 MV F, Panacol has developed another adhesive system certified for use in the medical industry.
In addition to its primary curing - UV crosslinking - this adhesive offers secondary moisture post-curing. This means that components in medical devices can be cured in a process-safe manner and without thermal influence, even if shadow zones are present in component cavities.
Two challenges commonly arise in medical applications when bonding plastics or assembling PCBs and FPCBs. Not every plastic is transparent, which makes it difficult to cure UV adhesives in a process-safe manner. In most cases, thermal post-curing is relied upon. However, thermal curing often becomes the second challenge. Not all electronic components and plastics can be subjected to thermal stress. In these cases, curing with heat is not a viable option.
To address these challenges, Panacol has developed a new, stress-free adhesive solution specifically for medical device applications. The primary curing of Vitralit 8050 MV F can be carried out in seconds with UV or LED UV light. LED curing units with a wavelength of 405 nm, such as the LED Spot 100 IC from Hönle, are best suited here. Secondary curing of the adhesive in the shadow areas that are not reached by the UV/visible light takes place through a moisture curing process. Surface and atmospheric moisture reacts with the adhesive to initiate a curing process. Unlike moisture curing cyanoacrylates, Vitralit UD 8050 MV F can be processed reliably because its primary curing is based on UV crosslinking. Moisture in the air does not cause the adhesive to cure while still in the dispensing needle. This offers the user a wide process window. In addition, there are no blooming of frosting effects on the plastics, which can occur when using cyanoacrylates.
Vitralit 8050 MV F is certified according to ISO 10993-5/-10/-23 biocompatibility testing. Since the dual-curing adhesive exhibits high adhesion to many different substrates, it can be used for a wide variety of bonding applications. The UV acrylate is suited for fixing batteries on glucose sensors (corner bonding). It can also be used as a glob top for protecting SMD components. The adhesive will cure reliably and stress-free, even in the shadow areas under the bonding wires. When used for structural bonding, Vitralit 8050 MV F can be applied between transparent and non-transparent substrates. Bonding is accomplished in seconds with UV/visible light. Shadowed areas will subsequently post-cure with moisture. Due to the high ionic purity of Vitralit 8050 MV F, the adhesive can be processed on metallised surfaces without hesitation. For optical quality control of the bond, Vitralit 8050 MV F is additionally equipped with fluorescent markers that can be excited with short-wave light.
The latest medical adhesive in Panacol's portfolio allows the company to offer a wider range of different adhesive systems for the medical electronics and medical wearables market. From UV acrylics and UV epoxies to electrically conductive products and conventional thermosetting epoxies, applications from structural package bonding to needle bonding and PCB bonding solutions can be provided.
